Chapter 4 - Digitizer Manager Image Capture

Allow users to capture the images of the paper patterns and save them in the computer.

Supported Camera And System Requirement

1. Support Canon EOS Series

   

2. The shooting distance need to be more than 110cm.

   

3. System requirement and recommended hardware specification.

   

4. Accept V notches tailoring on the pattern (Not accept other painting notches and inner line on the pattern).

5. Can not read multiple patterns drawing in single paper.

Setup The Camera

How to setup the camera

1. Set the power switch to [ON] and set the Mode Dial to (Scene Intelligent Auto)

   

2. Connecting the camera to the PC

   

3. The camera is connected to PC successfully when this window pops up

   

4. Keep your camera and pattern paper parallel, with a distance more than 110 cm.

   

Capture Image

How to capture image by using Digitizer Manager

1. Open Digitizer Manager, click menu [Options] - [Calibration].

   

2. Enter original position in X, Y and click calibration.

   1. Pattern Paper must be placed inside the frame from camera preview
   2. Keep pattern X, Y axis parallel to the X, Y axis in camera preview.

   

3. Calibration Completed -> OK.

   

4. Click menu [File] - [Take Picture]

   

5. Lay a white paper on checker board paper, put patterns on the paper. Click [OK]. Check patterns in your job list.

   

6. Open Pattern Design Application, click menu [File] - [Open Digitizer...].

   

7. Select the “Job List” you want, click [OK] button.

   

8. Now you can design your patterns in Pattern Design.